Fuel Sensor M for Up to 100cc and 200N Turbines, CORE/Jeti EX-BUS, from Smoke Systems

With its measuring range of 15 - 200ml/min (in pressure lines up to 800 ml/min), this sensor is well suited for large combustion engines greater than100ccm and turbines up to approx. 200N thrust. The fuel sensor is simply inserted into the fuel line and measures the flow in the fuel line. Gasoline and diesel/kerosene as well as methanol can be used as fuel. Installation is very easy with the screws provided.

This telemetry sensor (for PowerBox P²BUS and Jeti EX-BUS) measures the fuel flow from the tank to the engine or to the turbine and can therefore reliably display the tank level.

Telemetry for CORE/ATOM and Jeti
The fuel sensor can be connected to the Jeti EX-BUS and the PowerBox P²BUS. The protocol used is automatically recognized by the sensor. The settings in the sensor are also made via the BUS. A separate programming device is not required. With the Jeti, the setting is made via the JetiBOX in the transmitter and with the PowerBox via the sensor menu.

Only a few settings need to be made.

Reset channel: The fuel gauge is reset manually after refueling via a freely selectable channel.

tank volume: The tank size is set here and saved in the sensor.

Reserve: This is the amount of fuel left in the tank when the alarm goes off.

The sensor is immediately ready for use. As soon as the fuel sensor is connected to the bus, it automatically adapts to the correct bus protocol.

The sensor supplies the following values:

• Tank capacity in ml
• tank content in %
• Reserve volume in ml
• flow in ml/min

The values shown are shown accordingly for Jeti.

• Weight: 50g
• Measuring Range: 15 - 200 ml/min
• Size: 75 x 40 x 25 mm (L x B x H)
• Protocol: EX-Bus, P²-Bus